Brilliance LED - LOW-VOLTAGE-BISTRO-STRING-T-CONNECTOR - T Connector for Low Voltage Bistro Light Strand

Spec Sheet

The Low Voltage Bistro String T Connector is an accessory to customize the length of the Low Voltage Bistro String Reel only.

Use with Brilliance Low Voltage Bistro String for wherever you have an end of SO cord.

Order one Low Voltage Bistro String T Connector for each center feed used.

INSTALLING THE BISTRO STRING T CONNECTOR

1. Unscrew the plastic nut from the SO Cable side of the connection.

2. Unscrew the throat coupler from the center coupler.

3. Using a Philips screwdriver, unscrew the two cable terminals on either side from each other. The middle terminal is not used for two conductor SO cable.

4. Strip the SO cable to reveal the black and white conductors, approximately 1-1/2 inches.

5. Pass the plastic compression nut over the SO cable rounded side first.

6. Insert the SO cable through the hole of the rubber grommet.

7. Strip the SO conductor cable, approximately 1/2 inch.

8. Insert the black and white conductors as directed below:
   The black cable goes in the terminal with L marked near the rounded edge.
   The white cable goes in the terminal with N marked near the rounded edge
   Nothing goes into the third terminal.

9. Tighten both terminal screws.

10. Once both conductors are attached, thread the throat coupler to the center terminal side screw together to tighten.

11. Thread the compression nut back on to the grommet side.

12. Hand tighten until the SO cable has been compressed. Do not overtighten.

13. Repeat these instructions for each side of the T connection.