Brilliance CARLSBAD-UG-MR16-BR-BLK-NL Carlsbad Underground Uplight MR16 Black NO LAMP
|Carlsbad Underground Uplight|
|Use||Well Lighting & Underground Up Lighting|
|Includes||LightingShrink Professional Crimp and Heat Shrink Cable Connector|
|Lamp||MR16, 4W, 2700K, 30°|
The Carlsbad fixture is available in the following finishes: machined copper, brass, or black brass (Cerakote®).
Machined copper and brass offer a beautiful living finish that weathers over time to a unique patina.
Black brass fixtures with Cerakote® H Series ceramic coating offer superior corrosion resistance, durability, chemical resistance, and thermal stability.
To clean the fixture, periodically wipe it down with a mild soap and water.
INSTALLING THE LAMP
Remove the rear cap and pull out the spring.
Set the MR16 lamp on top of the spring and plug it into the socket.
Insert this assembly into the fixture body with the front of the lamp toward the lens.
Screw the back cap onto the fixture body and hand tighten.
INSTALLING THE FIXTURE
Dig a hole in the ground approximately 8” wide by 10” deep.
Connect the power cable to the fixture, leaving 2 feet of wire coiled in the bottom of the fixture for future service.
Pour 5” of pea gravel in the hole.
Place the fixture in the center of the hole.
Add more pea gravel to fill the hole 1” before the fixture lip. This allows for proper drainage around the fixture.
Apply glass wax on top of the lens to protect against standing water.