Dim your low voltage landscape lights with the Letzgo AC Low Voltage Digital Dimmer. Designed with intelligent soft-start, short-circuit protection, transient protection, overload indication and trailing edge dimming, this is the ideal solution for dimming 12VAC lighting.
- Dims majority of dimmable lamps (LED, Halogen, Incandescent)
- Indoor / Outdoor rated weatherproof design
- IP67 (dustproof, water resistant, potted electronics)
- Supply Voltage 12 to 15 VAC
- No minimum load requirement
- 10A max load current
- Runs cool with > 98% efficiency.
- Overload indicator (lamps cycle off & on to indicate overload)
- Short-circuit protection with simple recovery
- Transient protection (supply side and load side)
- Extremely smooth trailing edge dimming
- Intelligent soft-start
- Designed, engineered and assembled in the U.S.A.
Lower installed cost than primary side dimmers
Dims most bulbs including dimmable LEDs
Perfect for indoor and outdoor applications
Overload indicator (bulbs blink to indicate overload)
Short-circuit protection with simple recovery
Transient protection (supply side and load side)
Extremely smooth trailing edge dimming
IP67 (dustproof, water resistant, potted electronics)
Intelligent soft-start
Technical Specs:
Operating voltage: 12VAC
Current capacity: 10A
Max load: 120W
Min load: None
Frequency: 50Hz - 60Hz
Sturdy Design
Potted electronics are completely protected.
Waterproof
IP67 rated - potted electronics
Fits in standard junction box
Fits in standard junction box with decora-style faceplate, allowing for lockable covers.
Blends in with landscaping
Standard junction box gray allows full attention to be given to the landscape.
Ultra smooth trailing edge dimming
Trailing edge dimming works with a wide range of dimmable LED bulbs without flicker.
Intelligent soft-start
Digitally controlled soft-start.
Short circuit protection with simple recovery
Solid state short circuit protection with automatic re-try and fail-safe shutdown after 10 seconds.
Dimmer resets with power cycle or turning knob to off and back on.
Overload indicator
Bulbs blink to indicate an overload condition.
Digital dimming control
Using digital control extremely fine-tuned dimming is achieved.
Voltage In = Voltage Out when dimmer is turned full-on.
No installer adjustment required
Simply connect wires and use dimmer.
Runs cool!
Runs cool under all loads, no faceplate heatsink required.
