Rain Bird PSR220-IVM 220V LX-IVM Pump Start Relay
Brand: Rain Bird | SKU: PSR220-IVM
Product Overview
Use PSR220-IVM to switch power to a compatible single-phase irrigation pump from a Rain Bird ESP-LXIVM or ESP-LXIVM Pro controller. This is the 220V model. The two-wire controller sends its pump command through a required IVM-OUT field device.
Key Features
- Designed for the LX-IVM two-wire system with an IVM-OUT interface.
- Powder-coated steel NEMA 3R enclosure with grounding provision.
- Rain Bird rates the power contacts at 28 full-load amps at 240 VAC.
Common Uses
- Pump start control for an LX-IVM irrigation zone using a compatible single-phase pump.
- Replacing a PSR220-IVM when the pump and supply match the relay nameplate.
Technical Specifications
- Model: PSR220-IVM. Rain Bird designates this the 220V version.
- Power contact rating: 28 FLA at 240 VAC. Largest motor listed at 240 VAC: 5 hp.
- Short-circuit rating at 240 VAC: 5 kA. Frequency: 60 Hz.
- Controller interface: IVM-OUT field device required.
Dimensions
Enclosure: 6 inches wide × 6 inches high × 4 inches deep. Allow clearance for conduit and service access.
Compatibility & Installation Notes
Have a qualified installer match the supply and pump nameplates to the relay and verify the motor full-load current and protection requirements. Use the Rain Bird IVM-OUT pump-start wiring diagram. The relay switches the pump supply circuit. Use the required motor protection for the installation.
Frequently Asked Questions
Which controller works with PSR220-IVM?
Use an ESP-LXIVM or ESP-LXIVM Pro controller with the required IVM-OUT field device.
What pump rating should I check?
Rain Bird lists up to 5 hp and 28 full-load amps at 240 VAC. Have the installer confirm the pump and relay nameplates and the required motor protection.
How much room does the enclosure need?
The enclosure is 6 inches wide, 6 inches high and 4 inches deep. Allow additional clearance for conduit and service.
Why Buy from Big Frog Supply?
Choose PSR220-IVM when an LX-IVM two-wire installation needs pump start control for the 220V class. Check the 28 FLA rating at 240 VAC against the pump nameplate, then allow room for the 6 × 6 × 4-inch enclosure and the IVM-OUT interface.