INSTALLATION

INSTALLING THE LAMP

1. Loosen the allen screws on the lens cap and remove. 

2. Install the lamp into the socket and adjust the gimbal the proper direction.

3. Return the lens cap and tighten the screws to a snug hand tight.

INSTALLING THE FIXTURE

1. Dig a hole in the ground approximately 8” wide by 10” deep.

2. Connect the power cable to the fixture, leaving 2 feet of wire coiled in the bottom of the fixture for future service.

3. Pour 8” of pea gravel in the hole.

4. Place the fixture in the center of the hole.

5. Add more pea gravel to fill the hole 1” before the fixture lip. This will allow for proper drainage around the fixture. 

6. Apply glass wax on top of the lens to protect against standing water. 

Wattage: 4W
Kelvin Temperature: 2700K
Beam Spread: 30 Degrees
Lamp Type: MR16
Will accept the Chameleon MR16