Black Diamond PAR36 Angled Top Well Light w/PAR36 Gimbal NL

The Black Diamond PAR36 Well Light comes in angled. All glass tops come in a black brass baked enamel finish. It is available without a lamp. This well light is fitted for any of our PAR36 lamps and really comes to life with the Chameleon PAR36 for RGBW applications.

PAR36 WELL LIGHT

PERFECT FOR LARGE TREES AND OTHER STRUCTURES

Well Light for PAR36 Lamps

Available in Flat Top, Grate Flat Top and Angled T

op Comes with a Stainless Steel Heavy Duty Gimbal and Black Brass Baked Enamel Cover with Glass

Use with Brilliance Chameleon PAR36 Lamps for RGBW

The top of the Black Diamond PAR36 fixture is made of black brass baked enamel and the body is made of composite material.

To clean the fixture, periodically wipe it down with a mild soap and water.

INSTALLING THE LAMP

1. Loosen the thumbscrew on the lens cap and remove the lens cap and the stainless steel gimbal from inside the Black Diamond PAR36 Well Light.

2. Install the lamp and snap it into the gimbal.

3. Return the gimbal to the well light.

4. Place the lens cap and tighten the thumbscrew to protect from debris.

INSTALLING THE FIXTURE

1. Dig a hole in the ground approximately 12” wide by 14” deep.

2. Connect the power cable to the fixture, leaving 2 feet of wire coiled in the bottom of the fixture for future service.

3. Pour 8” of pea gravel in the hole.

4. Place the fixture in the center of the hole.

5. Add more pea gravel to fill the hole 1” before the fixture lip. This allows for proper drainage around the fixture.

6. Place the specified lens assembly on the top of the fixture and tighten the set screw. Use the specified lens in all applications to protect from debris.

7. Apply glass wax on top of the lens to protect against standing water.